Procedures

Configuration by the Serial Console

Procedure to enter serial console mode on C20 - C22

• Turn off the power of the device.
• Connect the PC to the C1 micro-USB port of Ethernet converter using the dedicated USB/UART converter.
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button (or connect Din pin to GND pin if the button is not mounted).
• Turn on the power and wait a few seconds until the orange LED lights up.
• Release the button (or disconnect Din pin from GND pin).

Procedure to enter serial console mode on C23 - C25

• Install STM32 Virtual COM Port Driver.
• Turn off the power of the device.
• Connect the PC to the C1 micro-USB port using the USB cable (or use the dedicated USB/UART converter).
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power and wait a few seconds until the yellow CN LED lights up.
• Release the button (or disconnect Din pin from GND pin).

Redisage Configurator

Configuration procedure

• Change the device port service to the RemoteCOM. 
• Set up a port number.
• Enable or disable encryption.
• If encryption is enabled create a password.
• In the Redisage Configurator click add the device and then set the COM number and the service port.
• If encryption is enabled enter a password.
• Click save changes.
• Connect to the configured serial COM port via terminal software.

Service mode

Procedure to enter service mode for C20 - C22 converters

• Turn off the power of the device.
• Connect Ethernet converter to the dedicated USB/UART converter via the microUSB port.
• Connect the USB/UART converter to the PC.
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power.
• Wait until the ST indicator (red LED) lights up.
• Release the S1 button.
• If the process is successful, service commands can be typed into the terminal.

Procedure to enter service mode for C23 - C25 converters

• Install STM32 Virtual COM Port Driver (if it was not done before).
• Turn off the power of the device.
• Connect Ethernet converter directly to the PC (the dedicated USB/UART converter is not obligatory).
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power.
• Wait until the ST indicator (red LED) lights up.
• Release the S1 button.
• If the process is successful, service commands can be typed into the terminal.