Recently Updated Pages

This page presents capabilities of the Ethernet Converters configuration. First of all, make su...

The Open IoT and IIoT Gateway P02 variant contains SMA connector for a WiFi/Bluetooth antenna.

Link to repositories: C This example allows you to check the Gateway's IP address. Co...

P01 P02 Features Open IoT gateway ESD protection for the RS485 data line Power supply: +...

Features Features Open IoT gateway ESD protection for the RS485 da...

The Open IoT Gateway contains a tactile switch mounted to the PSU board, which can be program...

The Gateway has 4 RS232/RS485 sockets depending on the version.   P10 (4x RS232) The P10 g...

MicroUSB ensures access straight to UART interface (UART4). The Open IoT Gateway does not hav...

There is a possibility of connecting peripheral I2C sensors. The board has dedicated pins for...

The Open IoT Gateway has a built-in Serial EEPROM with a secure element connected to the STM3...

Install IDE & Programmer Download and install STM32CubeIDE for ability to creating own progr...

P10 P11 P12 Features Open IoT gateway ESD protection for the RS485 data line...

Link to repositories: C This script tests internal communication between serial ports w...

CGM Rev. 3.1 Element Connection LED Power LED +3V3 LED1 PG6 ...

Link to repositories: C A simple program for scanning and displaying addresses of con...

Link to repositories: C A simple blinking LED example intended for the Open IoT Gateway...

Link to repositories: C Simple tactile switch example intended for the Open IoT Gateway...

Link to repositories: C This example uses UART4 in the MCU which is reserved for the USB ...

The Gateway has a Serial flash memory which can be programmed via SPI.

The Ethernet interface is provided by the IP101G physical layer. An external board with an RJ...