Data Sheet

C10 C11 C12 C13

Features

Automatic RS485 direction control
ESD protection for the RS232/485 data line
Power supply: +12 to +30 VDC or 24 VAC
3000 VDC isolation protection on the RS-485 side
Transmission speed up to 115200 bps
Tx, Rx and power LED indicators
RS485 embedded termination 120 ohm
Operating temperatures: -40°C to +75°C
DIN-rail mounting
Compact size - single module format (1M)
Dimensions: 90x56.4x17.5 mm
3 years warranty
Customization of OEM is welcomed

Introduction

Most industrial computer systems provide standard RS232 serial ports. Though widely accepted, RS232 has limited transmission speed, range, and networking capabilities.

The RS485 standards overcome these limitations by using diﬀerential voltage lines for data and control signals.

The C10 makes it easy to build an industrial grade, a long-distance communication system using standard PC hardware, as it converts RS232 signals into isolated RS485 signal with no need to change any hardware or software.

The design of the isolation between the C10 - C12 is diﬀerent. If the user wants to supply power from the PLC/PC, the C10 or C12 should be used, otherwise, the isolation will be broken.

Specification

Redisage PN		C10	C11	C12	C13
Converter ports		1 x RS232 & 1 x RS485
Power	Voltage	12-30 VDC / 24 VAC	12-30 VDC
	Power	< 1 W
Frame ground protection		yes
Serial interface	RS232	TxD, Rx, GND
	RS485	A, B
3000 VDC isolation		3-way	on RS232 side	on RS485 side	N/A
Baud rate		up to 115200 bps
LED indicators		communication Tx, Rx and power
RS485 termination		120 ohm manually enabled
Connector	RS232	3 pin terminal block max. 2.5 mm² wire
	RS485	3 pin terminal block max. 2.5 mm² wire
	Power	3 pin terminal block max. 2.5 mm² wire
Transmission distance	RS485	max. 1,200 m at 9.6 kbps; max. 400 m at 115.2 kbps (Belden 9841 2P twisted-pair cable, if diﬀerent cables are used, the transmission distance may change)
	RS232	max. 15 m at 115.2 kbps
Mounting and enclosure		DIN rail, plastic PA - UL 94 V0, black/green
Temperatures		-40°C to +75°C operating and storage
Humidity		10 - 90% RH, non-condensing
ESD protection		±4 kV contact discharge / ±8 kV air discharge
Certification		CE, RoHS