Skip to main content
Advanced Search
Search Terms
Content Type

Exact Matches
Tag Searches
Date Options
Updated after
Updated before
Created after
Created before

Search Results

9 total results found

Programming

STM32 Open IoT and IIoT Gateways User Manual

Install IDE & Programmer Download and install STM32CubeIDE for ability to creating own programs. For device programming, you must install STM32CubeProgrammer. Follow the instructions located on the producer's site. Software is available on Windows, Linux ...

I2C scanner

STM32 Open IoT and IIoT Gateways Examples

Link to repositories: C A simple program for scanning and displaying addresses of connected devices via I2C bus.

Pin Map

STM32 Open IoT and IIoT Gateways User Manual

CGM Rev. 3.1 Element Connection LED Power LED +3V3 LED1 PG6 LED2 PH14 LED3 PA10 LED4 PH12 LED5 PI9 ST3232BTR_1 UART RS232 Transceiver (P10 & P11) T1_IN USART1_TXD T2_IN USART6_TXD ...

Attachments

Ι Common Resources Ι

Niniejsza strona służy jedynie do umieszczania załączników, które będą wysyłane do klientów.Nie należy udostępniać klientom tej strony. Jest ona widoczna, ale tylko gdy użytkownik ma link. Służy to tylko do permisji pobierania załączników przez klienta/użytkow...

Introduction

Modbus Ethernet Wi-Fi Gateways User Manual

Modbus Ethernet Wi-Fi Gateways (G11 - G13) Modbus gateways allow data transmission between LAN hosts, Wi-Fi hosts, and serial devices by converting Modbus protocols (Modbus TCP and Modbus RTU/ASCII). They are intended to be used in industrial networks especia...

Hardware

Modbus Ethernet Wi-Fi Gateways User Manual

Modbus Ethernet Wi-Fi Gateways (G11 - G13) Modbus Gateway can be installed on any device from Redisage G11 - G13 Modbus Gateways family. Features Features       2-mode Ethernet + Wi-Fi Modbus Gateway ESD protection for the...

Configuration by the Web Page

Modbus Ethernet Wi-Fi Gateways User Manual

Modbus Ethernet Wi-Fi Gateways (G11 - G13) This page presents capabilities of the Ethernet Converters configuration. First, make sure that the converter is connected to the power supply and to the LAN using a patchcord or wireless via Wi-Fi. If the device has...

Configuration by the Telnet Console

Modbus Ethernet Wi-Fi Gateways User Manual

Modbus Ethernet Wi-Fi Gateways (G11 - G13) The device can be also configured via the Telnet Console. Firstly, make sure that converter is connected to the power supply and to the LAN using a patch cord. Knowledge of the device’s IP address (default is 192.168...

Configuration by the Serial Console

Modbus Ethernet Wi-Fi Gateways User Manual

Modbus Ethernet Wi-Fi Gateways (G11 - G13) Another way to configure the device is via a serial console. In case of the G11 - G13 Modbus gateways an additional USB/UART converter is needed. Procedure to enter serial console mode Turn off the power of the d...