Booting

• {{@143#bkmrk-emmc}}
• {{@143#bkmrk-sd-card}}
• {{@143#bkmrk-booting-after-the-po}}

eMMC

DIP switches positions

To boot from the eMMC the DIP switch No. 1 needs to be in position shown on the picture below.

(...)

Power supply

Connect a power supply to the pins shown on the picture below. The suggested parameters of the power supply are a DC voltage in range 12-24 V.

(...)

First boot

Connected power supply should initiate the first boot.

Console

Booting logs are displayed in the console, indicating a proper boot from the eMMC, as shown on the picture below.

SD card

DIP switches positions

To boot from the SD card the DIP switch No. 1 needs to be in position shown on the picture below.

(...)

Power supply

Connect a power supply to the pins shown on the picture below. The suggested parameters of the power supply are a DC voltage in range 12-24 V.

(...)

First boot

Connected power supply should initiate the first boot.

Console

Booting logs are displayed in the console, indicating a proper boot from the SD card, as shown on the picture below.

(...)

Booting after the power off command

If the device is turned off by inputting power off command in the terminal, the previous boot methods have to be initiated via the reset button placed on the front panel. Its placement is shown on the picture below.