Procedures

Configuration by the Serial Console

Procedure to enter serial console mode on G01 - G03

• Turn off the power of the device.
• Connect Ethernet converter to the dedicated USB/UART converter via the microUSB port.
• Connect the USB/UART converter to the PC.
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power.
• Wait until the ST indicator (orange LED) lights up (it should light up after red light - service mode).
• Release the S1 button.
• Login using user’s personal credentials or default login details.
• If the process is successful, configuration command can be typed into the terminal.

Procedure to enter serial console mode on G14 - G16

• Install STM32 Virtual COM Port Driver.
• Turn off the power of the device.
• Connect Ethernet converter directly to the PC (the dedicated USB/UART converter is not obligatory).
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power.
• Wait until the ST indicator (yellow LED) lights up.
• Release the S1 button.
• Login using user’s personal credentials or default login details.
• If the process is successful, configuration command can be typed into the terminal.

Service mode

Procedure to enter service mode for G01 - G03 gateways

• Turn off the power of the device.
• Connect Ethernet converter to the dedicated USB/UART converter via the microUSB port.
• Connect the USB/UART converter to the PC.
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power.
• Wait until the ST indicator (red LED) lights up.
• Release the S1 button.
• If the process is successful, service commands can be typed into the terminal.

Procedure to enter service mode for G14 - G16 gateways

• Install STM32 Virtual COM Port Driver (if it was not done before).
• Turn off the power of the device.
• Connect Ethernet converter directly to the PC (the dedicated USB/UART converter is not obligatory).
• Open the serial console (default baud rate is 115200 bps).
• Press and hold the S1 button.
• Turn on the power.
• Wait until the ST indicator (red LED) lights up.
• Release the S1 button.
• If the process is successful, service commands can be typed into the terminal.