RS232

Repositories:

• C
• MicroPython

In this example:

• UART1 (TX1 and RX1 pins) is configured as a receiver
• UART2 (TX2 and RX2 pins) is configured as a transmitter

Connect ports as in the picture.

In this way there is a possibility to do a test and adapt to working with external devices. On the developer side there is an option to configure serial port parameters.

Default settings:

• baud rate: 115200
• data bits: 8
• parity bits: 0
• stop bits: 1

After flashing, open serial port monitor and find out if the demo works properly.