RS232
{{@218#bkmrk-open-iot-and-iiot-ga}}
Repositories:Link to repositories:
In this example:
- UART1 (TX1 and RX1 pins) is configured as a receiver
- UART2 (TX2 and RX2 pins) is configured as a transmitter
Connect the ports as shown in the picture.
In this way there is a possibility to do a test and adapt to working with external devices. On the developer side there is an option to configure serial port parameters.
Default settings:
- baud rate: 115200
- data bits: 8
- parity bits: 0
- stop bits: 1
After flashing, open serial port monitor and find out if the demo works properly.
