Peripherals

RGB LED

STM32 Open IoT and IIoT Gateways (P10 - P12)


The Gateway is equipped with 5 RGB user LEDs. 4 are mounted directly to the board, and the fifth is next to the not-programmable blue power LED on the PSU board.

drawing-29-1737719679.png



Switch

STM32 Open IoT and IIoT Gateways (P10 - P12)


The Open IoT Gateway contains a tactile switch mounted to the PSU board, which can be programmed directly in the MCU.

drawing-29-1737719711.png


RS232 and RS485

STM32 Open IoT and IIoT Gateways (P10 - P12)


The Gateway has 4 RS232/RS485 sockets depending on the version.

 

P10 (4x RS232)

The P10 gateway is equipped with 2x ST3232BTR to ensure transmission in RS232 standard.

drawing-29-1737719852.png

P11 (4x RS485)

The P11 gateway is equipped with 2x MAX481CSA to ensure transmission in RS485 standard.

drawing-29-1737720135.png

P12 (2x RS232, 2x RS485)

The P12 gateway is equipped with 1x ST3232BTR and 2x MAX481CSA to ensure transmission both in RS232 and RS485 standardsm

drawing-29-1737719953.png

Ethernet PHY

STM32 Open IoT and IIoT Gateways (P10 - P12)


The Ethernet interface is provided by the IP101G physical layer. An external board with an RJ45 socket ensures a wired connection to the network.

drawing-29-1737720377.png

MicroUSB

STM32 Open IoT and IIoT Gateways (P10 - P12)

MicroUSB ensures access straight to UART interface (UART4). The Open IoT Gateway does not have inbuild FTDI converter so an external USB to UART FTDI converter is needed to run a serial port monitor on a PC.


drawing-29-1738845185.png



I2C EEPROM

STM32 Open IoT and IIoT Gateways (P10 - P12)

The Open IoT Gateway has a built-in Serial EEPROM with a secure element connected to the STM32 via I2C bus.

drawing-29-1737720455.png

Serial Flash

STM32 Open IoT and IIoT Gateways (P10 - P12)

The Gateway has a Serial flash memory which can be programmed via SPI.

drawing-29-1737720524.png

I2C Sensors (optional)

STM32 Open IoT and IIoT Gateways (P10 - P12)


There is a possibility of connecting peripheral I2C sensors. The board has dedicated pins for soldering devices. Below is a proposal for additional sensors that match the hardware.

drawing-29-1737720587.png

The presented devices are not included in the Open IoT Gateway.