The configuration is available only if devices are connected to the same Local Area Network as the computer used for it.
### Status page After a successful login, there should be an insight to important information such as: port status, service and ports which are in use and other details about the connection. [](https://doc.redisage.com/uploads/images/gallery/2025-09/Hrbimage.png) #### Changing username or password After clicking “Edit User” under the user icon, it is possible to change the username or the password. [](https://doc.redisage.com/uploads/images/gallery/2025-09/AiNimage.png) [](https://doc.redisage.com/uploads/images/gallery/2024-03/08cea4a8-e1e1-4241-a0ea-bf987363d2b7.png)If login details were forgotten, it would be necessary to do a factory reset via a USB/UART converter and a serial console.
### Ports page This page allows configuring the device’s ports. There is a toggle switch next to the “Port” label by which it is possible to turn ON/OFF any particular ports. [](https://doc.redisage.com/uploads/images/gallery/2025-09/0ALimage.png) {{@170#bkmrk-item-description-ser}}Changing port’s service closes all sockets connected to the ports.
In the UDP mode, port number 15051 is reserved for UDP broadcast service.
### Network page In this section, network settings can be changed according to target LAN parameters. [](https://doc.redisage.com/uploads/images/gallery/2025-09/NMsimage.png) {{@170#bkmrk-item-description-con}} {{@170#bkmrk-item-description-htt}} It is possible to obtain a dynamic IP address. Just switch configuration method from static IP to DHCP (automatic). This process may cause some issues with identifying converters in LAN unless there is an access to the device which is responsible for allocating IP addresses. Keep in mind that in case of changed IP address user needs to type a new IP in the address bar and log in again. ### Device page On the device page there are tools used to a firmware update, a factory reset and a device reboot. [](https://doc.redisage.com/uploads/images/gallery/2025-09/Hqtimage.png) {{@170#bkmrk-item-description-fir}} #### Firmware update The device firmware update must not be interrupted. Update the device only if experiencing issues, being instructed to do so by our support or requiring the latest features/bugfixes. Failure during the update may 'brick' the device and make it unusable. [](https://doc.redisage.com/uploads/images/gallery/2025-09/1Ijimage.png)Use the **remote-com-esp32.fir** file for a firmware update.
#### Factory reset To restore default settings, press the “Factory Reset” button. After that, user will be asked to type “RESET”. Then it will take a few seconds to reload the web page and restart the device. After the reset use default login details (login: **admin**, password: **admin123**; default IP**: 192.168.100.100**). [](https://doc.redisage.com/uploads/images/gallery/2025-09/eCHimage.png)