Procedures

Configuration by the Serial Console

Procedure to enter serial console mode on C30 - C32

• Turn off the power of the device.
• Connect Ethernet converter to the dedicated USB/UART converter via the microUSB port.
• Connect USB/UART converter to the PC.
• Open the serial console (default baud rate is 115200 bps).
• Short the FG and GND ports.
  
• Turn on the power.
• Wait until the ST indicator (orange LED) lights up (it should light up after red light - service mode).
• Open the the DI and GND ports.
  
• Login using user’s personal credentials or default login details.
• If the process is successful, configuration commands can be typed into the terminal.
  

Redisage Configurator

Configuration procedure

• Change the device port service to the RemoteCOM. 
• Set up a port number.
• Enable or disable encryption.
• If encryption is enabled create a password.
• In the Redisage Configurator click add the device and then set the COM number and the service port.
• If encryption is enabled enter a password.
• Click save changes.
• Connect to the configured serial COM port via terminal software.

Service mode

Procedure to enter service mode for C30 - C32 converters

• Turn off the power of the device.
• Connect Ethernet converter to the dedicated USB/UART converter via the microUSB port.
• Connect the USB/UART converter to the PC.
• Open the serial console (default baud rate is 115200 bps).
• Short the DI and GND ports.
  
• Turn on the power.
• Wait until the ST indicator (red LED) lights up.
• Open the the DI and GND ports.
  
• If the process is successful, service commands can be typed into the terminal.